iHome IA9 - Manual (Page 7)

5
Using the Unit
Snooze Operation
1. Default snooze time is 9 minutes. To program a custom snooze time, press and hold the Snooze Button during normal
operation (when alarm is not sounding) until the snooze minutes display appears. Press the + or - Button to set the
snooze timer from 1 to 29 minutes. Press and release the Snooze/Dimmer Button to exit snooze setting mode.
2. Press and release the Snooze/Dimmer Button after an alarm sounds. The alarm will be silenced for the set snooze
duration time then sound again. Snooze can be pressed several times during the 1 hour alarm cycle.
Sure Alarm
The unit has a sure alarm feature. If back-up batteries are installed, the buzzer alarm will still sound in the event of a power
failure. Tip: Download the free iHome+Sleep app for advanced alarm, snooze and sleep functions
Charging your iPhone/iPod
1. Gently dock your iPhone or iPod. While an iPhone/iPod is docked in the unit and the unit is connected to AC power, it
recharges (until fully charged).
Listening to iPhone/iPod
1. Dock the already playing iPhone/iPod in Dock. The unit will automatically turn on and you will hear the music playing
from your iPhone/iPod.
Note: If the playing song volume is too low on the iPhone/iPod, the unit may not detect iPod is in play mode.
Press and release the Button to play it.
2. When an iPhone/iPod is docked and in standby mode, press and release the Button to play it. “iPod” will appear
on the display to indicate iPod playing mode.
3. Press and release the Button again to pause play; press again to resume it.
4. Press the + or - Button to skip to the next or previous track on your iPhone/iPod. Press and hold the + or - Button to
search within a track.
5. Press and release the or to adjust the system volume.
6. Press and release the EQ Button as needed to select Treble, Bass, Balance or 3D Sound, then press the + or - Button
to adjust settings .
7. To turn off the unit, press and release the Button. iPhone/iPod will continue charging while docked.
Listening to Radio
Setting up Antenna
Extend FM wire antenna fully for best reception. Do not strip, alter or attach to other antennas.
Snap AM antenna cable into AM Loop Antenna Socket on back of unit and snap antenna into the antenna stand. Move
antenna 12” away from unit for best reception.
Tuning and Playing the Radio
1. Press and release the Mode Button as needed to turn on the unit and cycle through iPod, FM radio, AM radio and AUX
Line-in modes.
2. When the desired FM or AM mode is selected, press and release the + or - Button to tune the radio to a desired station.
The current radio frequency appears in the lower right of the display. Press and hold the + or - Button for a few seconds
to scan for the next clear station.
P7