Integra DPC-7.7 - Manual (Page 16)

16
Before Using the DPC-7.7
Notes:
• If the remote controller doesn’t work reliably, try
replacing both batteries.
• Don’t mix new and old batteries, or different types of
batteries.
• If you intend not to use the remote controller for a long
time, remove the batteries to prevent possible leakage
and corrosion.
• Flat batteries should be removed as soon as possible to
prevent possible leakage and corrosion.
To use the remote controller, point it at the DPC-7.7’s
remote control sensor, as shown below.
Notes:
• The remote controller may not work reliably if the
DPC-7.7 is subjected to bright light, such as direct
sunlight or inverter-type fluorescent lights. Keep this
in mind when installing the DPC-7.7.
• If another remote controller of the same type is used in
the same room, or the DPC-7.7 is installed close to
equipment that uses infrared rays, the remote control-
ler may not work reliably.
• Don’t put anything, such as a book, on the remote con-
troller, because the buttons may be pressed inadvert-
ently, thereby draining the batteries.
• The remote controller may not work reliably if the
DPC-7.7 is installed in a rack behind colored glass
doors. Keep this in mind when installing the DPC-7.7.
• The remote controller will not work if there’s an obsta-
cle between it and the DPC-7.7’s remote control sen-
sor.
Installing the Remote Controller’s
Batteries
1 Open the battery compartment, as
shown.
2 Insert the two supplied batteries (AA/
R6) in accordance with the polarity dia-
gram inside the battery compartment.
3 Close the battery compartment.
Using the Remote Controller
Chain Mode
Last Mem ory Dimmer Repeat Display
Standb y/On
Standby
Play Stop Pause
Disc Sk ip
Open /Clos e
Enter
DPC-7.7
30˚
30˚
Remote control sensor
Appr
ox
. 16 ft.
(5 m)
DPC-7.7