InFocus DH 24PD2 - Manual (Page 36)

35
English
OPTIONAL ACCESSORIES (sold separately)
1. Drilling anchor holes (rotation + hammering)
⅜ Drill bit (Slender shaft)
⅜ Drill bit (Taper shank) and taper shank adapter
Drill bit (slender shaft)
Outer diameter Effective length Overall length
3.4 mm
45 mm 90 mm
3.5 mm
SPECIFICATIONS
Voltage (by areas)* (110V, 230V)
Power Input 720W*
No-load speed 0 – 1050 min –1
Full-load impact rate 0 – 4600 min –1
Capacity: concrete 3.4 – 24 mm
steel 13 mm
wood 32 mm
Weight (without cord and side handle) 2.8 kg
Dust collecting adapter
Max. hole-drilling depth: 100 mm (adjustment possible between 0 and 100 mm)
Diameter of drill: 3.4 – 24 mm
Max. length of drill (overall length): 270 mm
Dustbag capacity: 0.4 liters
*Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
(1) Case (Molded plastic) ................................................. 1
(2) Side handle ................................................................. 1
(3) Dust collecting adapter .............................................. 1
(4) Dust bag ...................................................................... 1 [Numbers (3) and (4) refer to use on concrete]
(5) Cap .............................................................................. 1
Standard accessories are subject to change without
notice.
Adapter for slender shaft
(SDS-plus shank) Drill bit (Slender shaft)
Drill bit (Taper shank) Taper shank adapter
(SDS-plus shank)
Cotter
Outer diameter
11.0 mm
12.3 mm
12.7 mm
14.3 mm
14.5 mm
17.5 mm
21.5 mm
Taper mode Applicable drill bit
Morse taper (No.1) Drill bit (taper shank) 11.0 ~ 17.5 mm
Morse taper (No.2) Drill bit (taper shank) 21.5 mm
A-taper Taper shank adapter formed A-taper or B-taper
is provided as an optional accessory, but the
B-taper
drill bit for it is not provided.