Ironman Fitness ASCENDER - Manual (Page 5)

5
Getting Started - The Ironman Fitness Ascender Elliptical will require some assembly. Unpack
the box in a clear area. Remove packing material. Do not dispose of packing material until
assembly is complete and unit is working properly. Place the unit on a clean level surface for
assembly. Make sure there is easy access to an electrical outlet. Before assembling, the unit
should be placed as close as possible to its final location. Locate all hardware bags, labeled
Figure 1, Figure 2, Figure 3, Figure 4, Figure 5, Figure 6, Figure 7, Figure 9, Figure 11. If you
are missing any bags, please call Ironman Fitness at 1-800-750-4766. Tools have been pro-
vided to assist with product assembly.
Assembly
Figure 1
Locate bag labeled Figure 1. Locate
console tube. Attach console tube to
main frame. Slide Tube down into main
frame. Connect the upper gearbox cable
to the gearbox cable located on the
unit. Connect the coaxial cable from the
console tube to the coaxial cable com-
ing from the unit. Connect the AV Cable
coming from the console tube to the
cable coming from the unit (figure 1).
Secure using three M10*80 mm hex head
screws extending through the frame and
console tube, three 10*20 Washers and
three crown nuts, M10*1.5. Use three
M10*120 hex screws to secure through
the front of the console tube and main
frame (figure 1a).
Note: Ensure that all wires are secure
inside console. Be careful not to pinch
wires.
Note: Do not tighten screws until
you have fully completed Figure 2.
Figure 1
M10*80 HEX SCREW
CROWN NUT, M10*1.5
M10*120 HEX SCREW
10*20 WASHER
CONSOLE
TUBE
GEARBOX
CABLE
Figure 1a
AV CABLE
ASSEMBLY
COAXIAL CABLE
COAXIAL CABLE