IOGear GUIP201 M1023 - Manual (Page 23)

23
1. Connect the USB cable on your printer
or multi function printer to the IOGEAR
GUIP201 and make sure your printer is
powered on. You will then see the connected
printer show up in the IOGEAR USB Server
utility underneath the “IOGEAR GUIP201…”
Select the printer from the list and click on
the “Connect” button.
Note: If your USB device does not show up on
the list, please try to disconnect and reconnect
the device to the USB Net ShareStation. Also,
please make sure the USB Net ShareStation
and your USB device are powered on.
Connecting to a USB Printer / Multifunction Printer