Integra DV-SP301 - Manual (Page 16)

16
Making Connections
Although you can reproduce the DVD Player’s sound from the TV speakers with the connections on pages 13, 14, and 15, connecting with
an amplifier provides you high quality dynamic sounds.
To reproduce Dolby Digital surround and DTS surround sound, you need to connect to an amplifier with a Dolby Digital and DTS decoder
respectively.
Notes
• When using the optical output jack, remove the protective cap and keep it safely. When the
jack is not used, replace the protective cap.
• The function of the upper and lower z connectors are the same. Connect to either one.
• A remote controller supplied with an Onkyo amplifier can be used to operate this DVD player.
•
Connecting the z cable only does not make the system operational. You must
also connect the analog RCA/phono cables as well.
■ Making a digital connection with the
amplifier
If your amplifier has a digital input jack, be sure to connect it to
either DIGITAL OUTPUT OPTICAL or COAXIAL jack on the
DVD player.
Note
DO NOT connect to the AC-3RF input (e.g. of a Dolby Digital
receiver) which is reserved only for video disc players.
■ Making the analog connection with
the amplifier
If your amplifier has no digital audio input, you can make the
analog connection. If the amplifier has a Dolby Pro Logic decoder,
you can reproduce the Dolby Pro Logic surround sound.
Connecting to an Amplifier
(To enjoy the sound advantage of the DVD Player)
Be sure to set the “Digital Audio Out”
setting after connection using the Setup
explained on page 33.
MODEL NO. DV-SP301
DVD PLAYER L
R
OPTICAL
DIGITAL ANALOG
COAXIAL
AUDIO OUTPUT
VIDEO OUTPUT
Y
P B
P R
COMPONENT
VIDEO
S VIDEO
REMOTE CONTROL
L
DIGITAL
COAXIAL
DIGITAL
OPTICAL
R
REMOTE
CONTROL
To audio inputs
Signal flow
To digital input (coaxial)
To digital input (optical)
An amplifier or receiver
with a Dolby Digital or DTS
decoder or digital input
jacks
Audio (L)
Audio (R)
Audio (L)
Audio (R)
To z jack
Digital cable
(Not supplied)
Coaxial cable
(Supplied)
Audio cable (Supplied)
z cable (Supplied)
Connect the power cord
after all connections are
complete.
00_DV-SP301.book Page 16 Friday, April 18, 2003 4:18 PM