I/O Magic 16X - Manual (Page 13)

7
Hardware Installation
The following diagram shows you the rear view of your MagicDVD 16X Multi-Purpose
DVD-ROM drive (actual drive may look different). Familiarize yourself with the drive
before installing the unit into your computer. Locate where the drive will be connected
first and then make sure you have all the necessary parts for the connection.
Setting-up the “Mode Select” Jumper
On the rear panel of the MagicDVD 16X Multi-Purpose DVD-ROM drive, you will find
five pairs of jumpers. Use the jumper cap to set the device to CS, SL or MA mode
corresponding to your PC configuration (See Figure below). The default setting is
“Slave” mode. Improper or conflicting setting, will cause the unit to not be detected by
your computer.
MA = Master
SL = Slave
CS = CSEL of IDE interface.
Reserved = Do not use.