Integra TUN-3.7 - Manual (Page 28)

28
Changing the Remote ID
If the TUN-3.7’s remote controller interferes with other
Integra/Onkyo components located in the same room,
you can change the remote control ID. You can select
remote control ID #1, #2, or #3. By default, the remote
control ID is set to #1. If you change the ID, you must
also change the ID on the remote controller to match, as
explained below, otherwise, the remote controller won’t
work.
Changing the TUN-3.7’s Remote ID
Changing the Remote Controller’s ID
Note:
• The remote controller and TUN-3.7 must be set to the
same remote control ID. Otherwise, you won’t be
able to control the TUN-3.7 with the remote control-
ler.
1 Press the [Setup] button.
2 Use the Up and Down Arrow
[
]/[ ] buttons to select “Hard-
ware Setup,” and then press
[Enter].
With some tuner boards, there will
only be one option available and you
won’t need to use the Up and Down
Arrow [
]/[ ] buttons.
3 Use the Up and Down Arrow
[
]/[ ] buttons to select
“Remote ID.”
With some tuner boards, there will
only be one option available and you
won’t need to use the Up and Down
Arrow [
]/[ ] buttons.
Setup
/ / /
Enter
Number buttons
Return
Remote controller
Remote controller
Remote controller
4 Use the Left and Right Arrow
[
]/[ ] buttons to change the
remote ID.
You can select ID #1 (default), #2, or
#3.
5 Press the [Setup] button.
Once you’ve changed the TUN-3.7’s
remote ID, the remote controller will
no longer control the TUN-3.7, so you
must change the remote controller’s ID
to match, as explained below.
1 Before changing the remote con-
troller’s ID, change the TUN-3.7’s
ID first (see above).
2 Press the remote controller’s
[Return] button.
3 While pressing and holding
down the remote controller’s
[Return] button, press number
button [1], [2], or [3] for 3 sec-
onds to select ID #1, #2, or #3
respectively.
4 Check whether the remote con-
troller operates the TUN-3.7
properly.
Remote controller
Remote controller
Remote controller
Remote controller