ITT SMART SWITCH 801P5 User Manual
Page 21

Page 17 801P5 Smart Switch
TM
NOTE
PROGRAMMING MODE
In Programming Mode, you can:
•
Change the set points
•
Perform field pressure calibration
•
Program Window or Standard Mode
•
Change the password
•
Program display update time
•
Program delays for both switches
•
Scale the readout
•
Reset the Smart-Switch
TM
to factory defaults
If your unit includes the 4-20 mA option, you can:
•
Activate 4-20 mA mode
•
Calibrate the 4-20 mA
•
Scale the 4-20 mA output
If your unit includes the RS232 option, you can:
•
Set the BAUD rate
The unit will not function as a switch while in programming
mode.
ENTER PROGRAMMING MODE
To access the programming mode, press the [MENU] key (See
Figure 7). On the initial startup, no password is required. If you
have previously set up a password, you must enter it at this time:
1. When the displays show ---O, press the [UP/DOWN
ARROW] keys to set the first digit.
2. Press [SELECT] to move to the next digit.
3. Repeat this process until display shows the correct password.
4. Press [STORE] to enter programming mode.