InFocus M8V2 - Manual (Page 6)

English
6
4. Handle the bits very carefully.
5. Check the bit carefully for cracks or damage before operation. Replace cracked or
damaged bit immediately.
6. Avoid cutting nails. Inspect for and remove all nails from the workpiece before
operation.
7. Hold the tool firmly with both hands.
8. Keep hands away from rotating parts.
9. Make sure the bit is not contacting the workpiece before the switch is turned on.
10. Before using the tool on an actual workpiece, let it run for a while. Watch for vibration
or wobbling that could indicate improperly installed bit.
11. Be careful of the bit rotating direction and the feed direction.
12. Do not leave the tool running. Operate the tool only when hand-held.
13. Always switch off and wait for the bit to come to a complete stop before removing the
tool from workpiece.
14. Do not touch the bit immediately after operation: it may be extremely hot and could
burn your skin.
15. Always lead the power supply cord away from the tool towards the rear.
16. After changing the bits or making any adjustments, make sure the collet nut and any
other adjustment devices are securely tightened.
Loose adjustment device can unexpectedly shift, causing loss of control, loose rotating
components will be violently thrown.
5) Service
a)
Have your power tool serviced by a qualified repair person using only identical
replacement parts.
This will ensure that the safety of the power tool is maintained.
–WARNING–
To reduce the risk of injury, user must read instruction manual.
SPECIFIC SAFETY RULES AND SYMBOLS
1. Hold tools by insulated gripping surfaces when performing an operation where the
cutting tool may contact hidden wiring or its own cord.
Contact with a “live” wire will make exposed metal parts of the tool “live” and shock
the operator.
2. Use clamps or another practical way to secure and support the workpiece to a stable
platform.
Holding the work by hand or against your body leaves it unstable and may lead to loss
of control.
3. ALWAYS wear ear protectors when using the tool for extended periods.
Prolonged exposure to high intensity noise can cause hearing loss.