GIGABYTE 8S661FXMP-RZ - Manual (Page 16)

- 16 - 8S661FXMP-RZ Motherboard
English
8) F_PANEL (2x10 pins connector)
Please connect the power LED, PC peaker, reset switch and power switch etc. of your chassis front
panel to the F_PANEL connector according to the pin assignment above.
HD (IDE Hard Disk Active LED) Pin 1: LED anode(+)
Pin 2: LED cathode(-)
SPK (Speaker Connector) Pin 1: VCC(+)
Pin 2- Pin 3: NC
Pin 4: Data(-)
RST (Reset Switch) Open: Normal Operation
Close: Reset Hardware System
PW (Soft Power Connector) Open: Normal Operation
Close: Power On/Off
MSG (Message LED/Power/ Pin 1: LED anode(+)
Sleep LED) Pin 2: LED cathode(-)
NC NC
7) SATA0/SATA1 (Serial ATA Connector, Controlled by SiS964)
Serial ATA can provide 150MB/s transfer rate. Please refer to the BIOS setting for the Serial ATA
and install the proper driver in order to work properly.
Pin No. Definition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
7 1
S_ATA
(Control by SiS964)
SPK- SPK+
20
Speaker
Connector
19
IDE Hard Disk
Active LED
Reset Switch
2
Soft Power
Connector
MSG+
MSG-
Message LED/Power/
Sleep LED
PW-
PW+
1
HD+
HD-
RST+
RST-
NC
For more detailed Serial ATA RAID setup information, please
visit our website at http:\\www.gigabyte.com.tw.