Mordaunt-Short MS907W - Manual (Page 8)

Connecting via Line Input
If your amplification system has a dedicated subwoofer line
output then you should connect your MS907W via the Line
Input on the rear panel using a good quality phono lead.
Note that if your amplification system has a mono
subwoofer line out then use the Left/Mono socket on your
MS907W.
Connecting via High Level Connections
Do not compromise the performance of your system by
using inferior quality cables! Mordaunt-Short recommends
that high quality cables of 16 gauge or higher be used.
Your professional dealer will give you good advice.
Observing polarity is of the utmost importance while
connecting your loudspeakers. Ensure that the red (+)
terminals on your amplification system are connected to
the red (+) on the subwoofer, and black (-) on your
amplification system to black (-) on your subwoofer.
Important Note: Always unplug all A.C. powered
components before making any loudspeaker or
component connections. This will avoid the risk of electric
shock or damage to your equipment
Getting Started
8
Attaching feet to your subwoofer
Your MS907W subwoofer comes with feet and spikes
which must be fitted to space the down-firing speaker unit
the correct distance from the floor for optimum operation
The spikes attach to the bottom of the feet (as shown below
left).
There are eight pilot holes on the bottom of the speakers.
The feet are located and secured here with the wood
screws supplied (below right). Level as required.
Running In
Your new unit will require a total of approximately 10 hours
of normal use to allow the components to settle into their
working routine and reach their optimum performance.