MartinLogan E2 - Manual (Page 5)

Assembly 5
WARNING! Assembling the Statement e2
requires two people, except for step 12 of the
subwoofer tower assembly, which requires three
people. Do not attempt any part of the assembly
process with one person.
1 Place the primary subwoofer module in position on the
floor, (the primary module has 10 binding posts). Corner
placement is recommended—it is important to place
the sub towers as close to final position as possible, as the
final assembled tower weighs approximately 500 lb.
However, for assembly you must leave enough space
to have access to all sides of the sub tower. Place a level
in position as shown to level the module left to right.
Adjust the glider pads on the bottom of the cabinet to
achieve level.
2 Position the level as shown to level the primary mod-
ule front to back, adjusting the glider pads on the
bottom of the cabinet to achieve level.
3 Pick up a secondary module with an assembler on each
end and place carefully onto the primary module by
lining up the cone feet on the secondary with the
indentations at each corner of the primary module.
Use your index finger as shown to feel when the cone
feet are in position.
A
SSEMBLY
Subwoofer Tower Assembly
Figure 2
Figure 3
Figure 4