Marantz DV-12S1 - Manual (Page 20)

20
ENGLISH
Setting Up the
Player
1
Press Power button on the front panel.
• Press the POWER button on the Front panel to turn
the power on, and press it again to turn the power off.
Note
When it is required to remote control the power mode of this DVD
player, be sure to leave this switch in the power on mode.
2
Press SETUP.
When SETUP is pressed for the first time, the following
screen appears. Though the Setup Navigator may be
used more than once, this screen only appears the first
time
SETUP is pressed.
3
Move the cursor control joystick up or down to
make a selection.
• If you are going to use the Setup Navigator, it is not
necessary to change the setting on the first screen.
Please proceed to the next step.
• If you do not want to set up the player using the Setup
Navigator, use the cursor control joystic down to select
[Auto Start Off] at this time.
The Setup Navigator function may still be used at a
later time in manual Setup screen menu operation
(page 29).
4
Press ENTER.
The selection is entered and the next Setup Navigator
screen appears.
Use steps 3 and 4 as a basis for entering selections on all of
the Setup Navigator screens described on the following
pages.
To change the answer to a prior question
Move the cursor control joystick left to return to previous
screens. Please note, however, that you cannot go forward by
moving the
cursor control joystick right, so it will be necessary
to answer all the questions that occur after the screen that
was returned to.
To exit the Setup Navigator
Press SETUP while on any of the screens to exit the Setup
Navigator. Please note that if the Setup Navigator is exited
before all the questions are answered, no settings are
changed.
To return to the Setup screen
Press RETURN . The Setup Navigator is exited and the
Setup screen General menu screen appears. Please note
that no settings are changed if RETURN is pressed before
the Setup Navigator is finished.
Using the Setup Navigator
The Setup Navigator has been designed to simplify the
process of getting the DVD player ready to perform.
Designed as a series of on-screen multiple-choice questions,
the Setup Navigator automatically sets the audio, video, and
language settings according to how the questions are
answered. Once this procedure is complete, it will be
possible to begin using the DVD player to enjoy DVDs.
The procedure on this page describes the operations
necessary to function within the Setup Navigator screens. A
detailed description of the contents of each question that
appears on the screen can be found on the following pages.
When setting up for the first time
Some DVDs start playing automatically when loaded in the
player. Because the Setup Navigator cannot be used if a disc
is playing, it is recommended to set up the player using the
Setup Navigator before loading a DVD for the first time. If a
DVD has been loaded, be sure to press
STOP 7 before
proceeding.
Audio1 Audio2 General Language Video
Setup Navigator
Move Exit SETUP Select ENTER
Setup using the Setup Navigator
Setup Navigator
Auto Start Off
Start
MEMO CONDITION
LAST MEMO CLEAR
ENTER
3 1 2
SETUP RETURN
MENU TOP MENU
REPEAT
POWER
SEARCH +10
VIDEO ADJ.
OPEN/CLOSE
DISPLAY
ANGLE
PROGRAM
AUDIO
A-B
F.MEMO
SUBTITLE
0
9 8 7
6 5 4
RC-12DVS1
3, 4
1
2
RETURN
FL OFF STANDBY
PAUSE
POWER
RANDOM DIMMER
PLAY STOP DVD PLAYER DV-12S1 OPEN/CLOSE VIDEO ON/OFF
V-PART DVD AUDIO 192kHz
96kHz TRK CHP TEMAIN TOTAL DOLBY D DIG OFF GRP
TITLE VIDEO OFF L C LFE R LS S RS
PROGRESSIVE LAST MEMO
CONDITION
DOWN MIX
1