Magnadyne Marksman M5 - Manual (Page 6)

6
Alarm Mode Indicators
1. The LED indicator will provide information on 9 modes of security system operation:
LED is off = Alarm is disarmed.
LED is flashing = Alarm is armed.
LED is flashing in a 1 flash hold sequence = Tamper warning, alarm was triggered by the
current sensing sensor.
LED flashing in a 2 flash hold sequence = Tamper warning, alarm was triggered by the hood or trunk.
LED flashing in a 3 flash hold sequence = Tamper warning, alarm was triggered by an opened door.
LED flashing in a 4 flash hold sequence = Tamper warning, alarm was triggered by an electronic
sensor.
LED is on steady = Alarm is in the valet mode. (Ignition key is “on”)
LED flashes once every 5 seconds = Alarm is in the valet mode. (Ignition key is off”)
LED is flashing fast = Automatic arming timer is counting down or RF tamper rearming timer is
counting down.
2. The horn/siren will provide information on four modes of security system operation.
One horn/siren chirp = Security system is armed.
Two horn/siren chirps = Security system is disarmed.
Four horn/siren chirps = Tamper warning + security system is disarmed.
Press and hold the PANIC button (4) for more than 3 seconds and the security system will respond
in the following manner:
A. The horn/siren will begin sounding.
B. The parking lights will begin flashing.
To turn off the panic alarm, press and release the UNLOCK button on the transmitter. The horn/siren
will stop sounding and the parking lights will stop flashing.
Note: If you do not turn off the panic feature with the transmitter, the panic alarm will sound for 60
seconds and then turn off by itself.
Every time you disarm your Marksman security system with your transmitter, the security system will
start an RF protection mode countdown. This is a timed secondary protection mode to insure that the
radio signal used to disarm the security system was from your transmitter. After the system is disarmed
by radio signal, it will count down for 60 seconds and then become re-armed if no one enters the
vehicle.
Note: The feature is only active when the security system has been programmed to automatically arm.
Remote Panic
Secondary RF Protection Mode