Pontiac trans am / firebird 1993 – Metra Electronics 99-3009 User Manual
Page 4
3
4
Disconnect the negative battery terminal to
prevent an accidental short circuit. Using a
small set of pliers, grasp the retaining clip on
the back of the gear shifter handle and
remove the clip. Remove the gear shifter
handle. Unclip the center console and
remove. Remove (2) 7mm hex-head
screws exposed under the climate controls.
Unclip the radio trim bezel and remove.
Remove (2) 7mm hex-head screws securing
the factory head unit and disconnect the
wiring.
Disconnect the negative battery terminal to
prevent an accidental short circuit. Unclip
the entire dash trim bezel. Remove the
screws securing the factory head unit and
disconnect the wiring.
1
1
PONTIAC Grand Prix 1994-02
PONTIAC Grand Prix 1997-99
2
2
Disconnect the negative battery terminal to
prevent an accidental short circuit. Open
the glove box and remove (2) Phillips screws
exposed on the right edge of the radio trim
bezel. Unclip the bezel and remove.
Remove (2) 7mm hex-head screws securing
the factory head unit and disconnect the
wiring.
1
PONTIAC Sunfire 1995-99
Cut and remove all mounting tabs on the
Radio Housing EXCEPT tabs "C". (see
Fig. A). Using a dremel tool, cut and remove
the shaded portions of the sub-dash plastic.
This will provide the necessary depth for
installation. (see Fig. B). Skip to the
Installation Instructions for ALL VEHICLES
on Page #5.
2
Disconnect the negative battery terminal to
prevent an accidental short circuit. Unclip
the radio trim bezel. Remove (4) 7mm hex-
head screws securing the factory head unit
and disconnect the wiring.
1
PONTIAC Trans Am / Firebird 1993
2
"C"
"C"
"B"
"C"
Fig. A
Fig. B
Cut and remove all mounting tabs on the
Radio Housing EXCEPT tabs "C". The
mounting tabs can be identified by the
stamped letter on the back of each tab. Skip
to the Installation Instructions for ALL
VEHICLES on Page #5.
Cut and remove all mounting tabs on the
Radio Housing EXCEPT tabs "B". The
mounting tabs can be identified by the
stamped letter on the back of each tab. Skip
to the Installation Instructions for ALL
VEHICLES on Page #5.
Cut and remove all mounting tabs on the
Radio Housing EXCEPT tabs "C". The
mounting tabs can be identified by the
stamped letter on the back of each tab. Skip
to the Installation Instructions for ALL
VEHICLES on Page #5.