Marantz DR6000 - Manual (Page 11)

9
ENGLISH
RECORDING
MENU/
STORE CANCEL/
DELETE
0
9 8 7
6 5 4
3 2 1
CD CDR
ABC DEF GHI
JKL MN OPQ
RST UVW XYZ
DISPLAY SPACE SCROLL
FUNCTION
ENTER
Recordable ReWritable
POWER
CD RECORDER DR6000
PLAY/PAUSE STOP
REC
- + PUSH ENTER
EASY JOG
LEVEL PHONES
REC TYPE REW FF
FINALIZE DELETE CANCEL MENU STORE SOURCE ERASE
OPEN/CLOSE
DISPLAY SCROLL
ON/OFF
e r y
y
5 5 5 5 5 To start recording, press PLAY on the selected source.
➔ The CD-Recorder automatically starts to record. The re-
cording time left appears on the display.
• If, however, you start the source during a track, CD-
SYNC recording starts at the beginning of the next track
or after 2.7 seconds of silence in analog recordings.
• To check the elapsed recording time, press DISPLAY
(4, 58). (This can also be done during recording)
• The recorder stops automatically.
6 6 6 6 6 To stop recording manually, press 9 9 9 9 9 STOP (17, 68).
• If 9 STOP (17, 68) was pressed within 3 seconds after
pressing PLAY on the selected source, no recording will
take place.
• To interrupt recording, press 2 / ; PLAY/PAUSE (16) or ;
PAUSE (63).
To resume, press 0 REC (13) on the CD-Recorder.
After recording the display will show for sev-
eral seconds.
Note:
- Recordings from DAT, DCC or analog sources will only stop
after 20 seconds silence.
- MAKE CD is a recording mode for auto finalized after syn-
chronized recording. It takes about 1 minute to start auto fi-
nalizing after finish recording the last track. (WAIT appears
on the display.) If you press
9 STOP (17, 68) during WAIT on
the display, auto finalizing will be canceled.
Important:
If you want to play the recorded CD-R(W) disc on any regu-
lar CD player, it must first be finalized. See finalizing discs.
Finalized CD-RW discs play only on CD-RW compatible CD
players.
CD-SYNC
The CD-SYNC feature enables you to make fast and easy re-
cordings of a CD. Track increments are automatically detected
from the source material. Track increments cannot be added
manually. In analog source material a silence of 2.7 seconds or
more is automatically detected as a track increment.
1 1 1 1 1 Make sure the disc is absolutely free of scratches and
dust particles.
2 2 2 2 2 Connect the cable from an external CD player to the CD-
Recorder. (see INSTALLATION page 5 and 6.)
3 3 3 3 3 Press SOURCE (7) repeatedly until the selected source,
appears on the display (depending on the digital connec-
tion used):
➔ , or lights up and ,
or appears on the display.
4 4 4 4 4 With the CD-Recorder stopped, press REC TYPE (20).
once: to select ‘ ’;
twice: to select ‘ ’;
four times: to select ‘ ’;
➔ and start to flash.
The numbers between parentheses refer to the fold-out.
DR6000(U)_Eng_P01-10.p65 8/7/00, 1:35 PM 9