GE ZDIC150 - Manual (Page 12)

12
Care and Cleaning
Icemaker
Condenser
For best performance, brush or vacuum lint and
dirt from the condenser once a year.
A dirty or clogged condenser:
• Prevents proper airflow.
• Reduces ice making capacity.
• Causes higher than recommended operating
temperatures which may lead to component
failure.
1. Unplug the icemaker or disconnect power.
2. Remove the 2 screws in the lower access
panel and the 2 screws from the base grille
area of the front panel support. Pull forward
to remove the lower access panel.
3. Pull the bottom forward and then pull down
to remove the lower access panel.
4. Remove dirt and lint from the condenser fins
and the unit compartment with a brush
attachment attached to a vacuum cleaner.
5. Replace the lower access panel using the
4 screws.
6. Plug in the icemaker or reconnect power.
Icemaker
system
1. Press and hold OFF.
2. Wait 5 to 10 minutes for the ice to fall into the
storage bin. Remove all ice from the storage
bin.
3. Unscrew the drain cap from the bottom of the
water reservoir located inside the storage bin as
shown. Allow the water to drain completely.
4. Replace the drain cap.
5. Use the entire 16 oz. bottle of Nickel Safe
Ice Machine Cleaner rather than the amount
suggested on the bottle. Follow all safety
precautions on the bottle. Pour one bottle of
solution into the water reservoir. Fill the bottle twice
with tap water and pour it into the water reservoir.
Nickel Safe Ice Machine Cleaner by Nu Calgon
is available at appliance repair shops, or through
GE Parts and Accessories. Order part number
WX08X42870. In the U.S.A., call 800.626.2002 or visit
monogram.com. In Canada, call 1.888.880.3030.
6. Press and hold CLEAN. The CLEAN light will
begin to blink, indicating that the cleaning
cycle is in process. The cleaning time is
approximately 70 minutes.
7. When the indicator light becomes solid and
remains lit, the cleaning cycle is complete.
During the cleaning cycle, the system will
both clean and rinse itself.
8. After the cleaning cycle is complete, remove
the drain cap from the water reservoir to see
if any cleaning solution, green in color, is left in
the water reservoir. If cleaning solution drains
from the water reservoir, you should run the
clean cycle again. Be sure to replace the drain
cap before running the cycle again. If the cap
is not securely tightened, water can leak,
causing thin ice or no ice.
NOTE: Severe scale buildup may require repeated
cleaning with a fresh quantity of cleaning solution.
9. Press ON to resume ice production.
Water reservoir Drain cap