GE WSM2420S - Manual (Page 6)

HOW TO YOUR WASHER
Features and appearances may vary slightly
WARNINGTO reduce the risk of fire, electric shock, or injury to persons when using your
appliance, read the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance.
Load
See How to Operate Your for the above Dryer controls
Setting the Controls
Use the Suggested Fabric and Cycle Settings guide
to help you make the proper selections.
Select Water Level.
SMALL: Washer is less than 1/3 full of clothes.
MEDIUM: Between 1/3 and 2/3 full.
LARGE: Over 2/3 full.
For best cleaning results, the load must be able to move
freely in the water. Too
a load or too little water can
cause wear or tear of load items.
Temperature.
Cycle Selector knob clockwise to
your selected wash setting.
Selector knob
out to start the washer. If
you wish to
setting
after washer has started, push
-.
Cycle Selector knob into stop
STOP
the washer and reset to the new
position. Setting can be changed at any time.
Washer Lid Latch To Add Items After Washer Has
For easier loading convenience,
use the washer lid latch.
To hold the washer lid
up, lift the lid
it
snaps past the latch
under the control panel.
To release the lid, push
the lid latch up.
●
Turn off the washer.
●
Latch the washer lid.
●
Add any additional articles by submerging them next
to the agitator.
NOTE: When washing stockings, panty hose and
other easily tangled items, always handle separately.
To minimize tangling, we recommend the use of a net
LID
laundry bag.
How to Soak in Your Washer
the washer to fill and agitate for a few minutes to dissolve the
soaking agent. Then push in the Cycle Selector knob to stop the washer
(keep
closed) and allow to soak for as long as desired.
After desired soak period, pull out Cycle Selector knob to complete cycle.
6