beautypg.com

GE ZPBS360 User Manual

Installation instructions, Before you begin, Accessory panel kits

background image

BEFORE YOU BEGIN

Read these instructions completely and carefully.

Note to Installer

Be sure to leave these

instructions with the Consumer.

Note to Consumer

Keep these instructions with

your Owner’s Manual for future reference.

Installation
Instructions

ACCESSORY PANEL KITS

ZPSS360 – Stainless Steel
ZPBS360 – Black Acrylic

Kit Contents

• 2 Filler panels

(with ZPSS360 only)

• Door panel
• Grille panel

Tools Required

• Phillips screwdriver
• Safety glasses
• Gloves to protect against

sharp edges

• Wood block
• Hammer

REMOVE HANDLES AND TRIM

• Open the door to 90°. Remove the 6 Phillips head

screws from the door handle.

• Remove handle. Retain all screws.

• Remove 6 screws holding trim. Lift off trim.

Retain screws.

STEP 1

INSTALL PANELS

• Remove protective film from appearance panel.

• Slide panel into the door trim.

• If installing stainless steel panels, first slide filler

panel into the door trim, then slide stainless panel
into the trim.

• If necessary, tap with a wood block until panel slips

under the hinge side trim.

• There are two sets of holes in the handle side trim.

Replace side trim by installing the original screws
in the FRONT screw holes.

• Secure the handle to the door using the REAR

screw holes.

STEP 2

Use Rear Holes

to Secure Handle

Use Front Holes

to Secure Trim

This manual is related to the following products: