Nx-7002 for primary or backup reporting, Nx-7002 for primary reporting, Nx-7002 for backup reporting – GE NetworX NX-7002 User Manual
Page 24: Nx-7002, For primary reporting, For backup reporting, For primary or backup reporting
NX-7002
FOR PRIMARY OR BACKUP REPORTING
NX-7002 for primary reporting
The NX-7002 can be configured to be the primary transmitter. In this case, the NX-7002 acts
as the main alarm reporting device.
If the NX-7002 fails, for example, if there is no GSM coverage or there is jamming, if the
network of the provider is down or there are technical problems on the receiver side, another
device (the onboard dialler of the panel or an auxiliary dialler) can be configured to act as
backup. In this case, set location 2 to 255 (Other dialler) as backup for the NX-7002.
If another dialler is used as the backup device:
•
Enable the Autotest report options in that dialler.
•
Ensure that the reporting format used in the backup device is the same as the reporting
format used in the NX-7002.
If the NX-7002 fails to report over the GPRS network to the IP receiver, you can use a second
report control from the NX-7002 as backup. For example, use SMS reporting as the backup
report control. In this case, set location 1 to 1 (TCP/IP1) and location 2 to 5 (SMS1).
NX-7002 for backup reporting
The NX-7002 can be configured to transmit events only when the primary dialler (control
panel, auxiliary dialler) fails to do so. In this case, the NX-7002 acts as the backup reporting
device.
The NX-7002 can be configured as the backup device of the control panel in two ways:
1. Backup reporting using a report control (TCP/IP or SMS)
Select the desired report control in location 1 and set the corresponding report control as a
secondary (backup) report control in location 25.
2. Backup reporting using the GSM voice channel
In this case, the NX-7002 acts as a transparent backup device for the control panel. No
programming in the NX-7002 is required, except for the SIM PIN code in location 169. All event
reporting is programmed in the control panel.
The phone number must be programmed twice in the control panel:
•
Program phone number 1 as usual. For example, 011234567.
•
Enter a “10” in front of phone number 2. For example, 10011234567. This forces the NX-
7002 to dial the phone number instead of the control panel.
•
The special audio cable (included) must be stuffed between the NX-7002 and the control
panel. See NX-7002 layout and description for more information.
NX-7002 Installation manual
Page 24
09/02/05