FARGO electronic HDP600 - Manual (Page 213)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3) 7-2
Using the Disable Printing option____________________________________________________ 7-37
Using the Image Color tab (HDP600) ___________________________________________________ 7-38
Using the Image Color tab (continued) _____________________________________________ 7-39
Using the Image Color tab (continued) _____________________________________________ 7-40
Using the Image Color tab _______________________________________________________ 7-41
Using the Image Transfer tab _________________________________________________________ 7-42
Adjusting the Image Position controls ________________________________________________ 7-43
Adjusting the Transfer Dwell Time and Temperature ____________________________________ 7-45
Using the K Panel Resin tab __________________________________________________________ 7-46
Selecting the Full Card with the K Panel Resin tab ______________________________________ 7-47
Selecting the Defined Area(s) with the K Panel Resin tab _________________________________ 7-48
Selecting the Undefined Area(s) with the K Panel Resin tab _______________________________ 7-49
Defining the Area to activate the Card Grid ____________________________________________ 7-50
Measuring the Total Card area ______________________________________________________ 7-51
Measuring the Area to be positioned on the Card________________________________________ 7-52
Selecting the Print YMC under the K and Print K Only options ____________________________ 7-53
Using the Magnetic Encoding tab ______________________________________________________ 7-54
Using the Encoding Mode option ____________________________________________________ 7-55
Using the Encoding Mode option (continued) ________________________________________ 7-56
Encoding the Mode/Coercivity/Magnetic Track Selection_________________________________ 7-57
Encoding the Mode/Coercivity/Magnetic Track Selection (continued)_____________________ 7-58
Reviewing the Magnetic Track Options _______________________________________________ 7-59
Reviewing the Enable MLE Support checkbox _________________________________________ 7-60
Reviewing the Verification options __________________________________________________ 7-61
Reviewing the Shift Data Left ______________________________________________________ 7-62
Reviewing the ISO Track Locations__________________________________________________ 7-63
Sending the Track Information ______________________________________________________ 7-64
Reviewing the Sample String _______________________________________________________ 7-65
Reviewing the ASCII Code and Character Table ________________________________________ 7-66
Using the Lamination tab (only with Card Lamination Module) ______________________________ 7-67
Selecting the Lamination Position ___________________________________________________ 7-68
Selecting the Lamination Side ______________________________________________________ 7-69
Selecting the Lamination Type ______________________________________________________ 7-70
Adjusting the Transfer Dwell Time and Transfer Temperature _____________________________ 7-71
Selecting the Sensors button and Defaults button________________________________________ 7-71
Selecting the Sensors button and Defaults button________________________________________ 7-72