Yamaha A-S700 - Manual (Page 4)

2
En
1 POWER
Press inward to the ON position to turn on the power of
this unit. You can set this unit to standby mode by
pressing button on the remote control or turn on the unit
by pressing button on the remote control when this unit is
turned on.
Press again to release it outward to the OFF position to
turn off this unit.
Even when this unit is turned off, this unit consumes a small
amount of power to preserve the memory.
2 POWER on indicator
Lights up as follows:
ON: Bright
Standby mode: Dark
OFF: Off
3 Remote control sensor
Receives signals from the remote control.
4 INPUT selector and indicators
Select the input source you want to listen to.
The input source indicators light up when the
corresponding input sources are selected.
y
The input source names correspond to the names of the
connection jacks on the rear panel.
The input setting is retained for about 1 week after the power
cable is unplugged.
5 PHONES jack
Connect headphones for private listening.
Rotate the SPEAKERS selector on the front panel to the
OFF position to turn off the sound from the speakers.
6 SPEAKERS selector
Turn on or off the speaker set connected to the
SPEAKERS A and/or B terminals on the rear panel each
time the corresponding SPEAKERS selector is set to A, B
or A+B.
7 REC OUT selector
Select a source for recording independently of the INPUT
selector setting, allowing you to record the selected source
while listening to another source.
See page 11 for details.
8 BASS
Increase or decrease the low frequency response.
See page 10 for details.
9 TREBLE
Increase or decrease the high frequency response.
See page 10 for details.
0 BALANCE
Adjust the sound output balance of the left and right
speakers. See page 10 for details.
A LOUDNESS
Retain a full tonal range at any volume level.
See page 11 for details.
B CD DIRECT AMP and indicator
Reproduces CD sound in the highest signal quality
regardless of the INPUT selector setting.
The indicator above it lights up when this function is
turned on. See page 10 for details.
CONTROLS AND FUNCTIONS
Front panel
Note
Note