FMC Corporation - Talstar FMC L06 User Manual
FMC Corporation - Talstar Pumps
Table of contents
Document Outline
- Title Page
- Table of Contents
- 1.0 Important Safety Instructions
- 2.0 L06 - L16 Pump Features
- 3.0 Storage Instructions
- 4.0 Installation Guidelines
- 5.0 How to Start a Pump
- 6.0 Lubrication of Power End
- 7.0 Inspection and Preventative Maintenance Chart
- 8.0 Estimated Life of Wearing Components
- 9.0 Component Parts List
- 10.0 Service Procedures
- 11.0 Fastener Torque Requirements
- 12.0 Critical Clearances
- 13.0 Valve Removal and Installation Tools
- 14.0 Trouble-Shooting Pumps
- 15.0 Ordering Parts
- 16.0 Glossary of Commonly Used Terms
- 17.0 Reference Information
- List of Figures
- Figure 1: L11 - L16 Pump Assembly with Pinion Shaft
- Figure 2: L06 - L16 Pump Assembly with No Pinion Shaft (Includes HD & HV)
- Figure 3: Power End Components
- Figure 4: Fluid End Components
- Figure 5: AR Valve Assembly
- Figure 6: Using the Knock Out Tool
- Picture 1: Removing the valve from the seat
- Picture 2: Removing the valve from the fluid cylinder
- Figure 7: Valve Disassembly
- Figure 8: Eccentric Disc in Use
- Figure 9: Removing the seat
- Figure 10: Hydraulic Power used to Remove Valve Seat
- Picture 3: Mandrel Type Tool
- Figure 11: Mandrel Tool in use
- Figure 12: Threaded Tool in use
- Figure 13: Typical L Series Disc Valve Assembly
- Figure 14: Illustration of the P534694 and P534695 Ball Knock Out Tools