FUNAI ZV450TT8 - Manual (Page 11)

11 EN
Disc
Management
Recording
Playback
Introduction
Connections
Basic Setup
Editing
Function
Setup
VCR Functions
Others
Español
FUNCTIONAL OVERVIEW
Rear Panel
Note
• Do not touch the inner pins of the jacks on the rear
panel. Electrostatic discharge may cause permanent
damage to the unit.
• This unit does not have the RF modulator.
1. AC Power Cord (DVD/VCR)
Connect to a standard AC outlet to supply power to this
unit.
2. ANTENNA OUT jack (DVD/VCR)
Use to connect an RF coaxial cable to pass the signal
from the ANTENNA IN to your TV.
3. ANTENNA IN jack (DVD/VCR)
Use to connect an antenna.
4. AUDIO OUT jacks (DVD/VCR)
Use to connect a TV monitor, AV receiver or other
device with a RCA audio cable.
5. VIDEO OUT jack (DVD/VCR)
Use to connect a TV monitor, AV receiver or other
device with a RCA video cable.
6. VIDEO IN jack (L1) (DVD/VCR)
Use to connect external device with a RCA video
cable.
7. AUDIO IN jacks (L1) (DVD/VCR)
Use to connect external device with a RCA audio
cable.
8. S-VIDEO IN jack (L1) (DVD/VCR)
Use to connect the S-video output of external device
with an S-video cable.
9 . COMPONENT VIDEO OUT jacks (DVD only)
Use to connect a TV monitor with component video
inputs with a component video cable.
10. S-VIDEO OUT jack (DVD only)
Use to connect the S-video input of a TV monitor, AV
receiver or other device with an S-video cable.
11. AUDIO OUT jacks (DVD only)
Use to connect a TV monitor, AV receiver or other
device with a RCA audio cable.
12. COAXIAL DIGITAL AUDIO OUT jack (DVD only)
Use to connect an AV receiver, Dolby Digital decoder
or other device with a coaxial digital input jack with a
digital coaxial cable.
DVD
DIGITAL
AUDIO OUT
AUDIO
OUT
S-VIDEO
OUT IN
COAXIAL
L
R
L Y
P B
/C B
P R
/C R
R
L
R
OUT
IN
S-VIDEO IN --- AUDIO --- OUT
IN --- VIDEO --- OUT
COMPONENT
VIDEO OUT
DVD/VCR
ANTENNA
1
4
2
8 10 12 9 7 5 6 3 11