FUJITSU LT800P - Manual (Page 23)

21
G e t t i n g S t a r t e d
IrDA/FIR
port 1-4 An infrared transceiver built into the tablet
allows you to communicate with other
devices that are compliant with the IrDA
Standard Rev. 1.1. Effective range for infrared
communication is about 3 feet, and within 15
degrees off of center. A clear line-of-sight
path must exist between the IrDA port on the
tablet and the IrDA transceiver on the other
device.
Modem 1-4 Connect a telephone line to the optional
internal modem using a standard RJ-11
telephone plug.
Charging
Contacts 1-6 Install the tablet in an approved docking
device. The contacts provide DC input.
Mini-dock
port †
1-6 Connect the Stylistic LT800P mini-dock. Refer
to the documentation accompanying the
docking device for more information.
LAN Port
(RJ-45) 1-6 The LAN (RJ-45) is used to connect the
internal Ethernet device to a LAN or
broadband devices such as a cable modem,
DSL, or satellite internet.
Infrared
keyboard
port 1-6 An infrared receiver built into the tablet allows
you to communicate with a wireless infrared
keyboard or wireless infrared mouse. The
infrared port on the keyboard or mouse works
optimally between 10 to 30 cm
(approximately 4 in. to 12 in.) from the
keyboard infrared port, located on the
bottom-left edge of the tablet. Ensure that a
clear line-of-sight path exists between the
infrared receiver on the tablet and the infrared
transmitter on the keyboard.
† Remove the mini-dock interface cover to access this port.
Table 1-2. Peripheral Connectors/Interfaces
Connector/
Peripheral
Fig.
Ref.
Tablet Icon Purpose
58-0867-01.book Page 21 Thursday, February 13, 2003 1:18 PM