FMI Wall Mantel and Base with Trim W32DS - Manual (Page 4)

119360-01
Rev. B
07/06
119360 01
2701 Industrial Drive
P.O. Box 90004
Bowling Green, KY 42102-9004
Technical Service and Parts
1-866-672-6040
NOt A UPc
6. Fireplace with louver door: Lower bottom louver door. Use
two screws provided in hardware package and attach fire-
place to wooden base (see Figure 10). Close louver door
Fireplace with fixed louver: Before installing logs or burner
assembly (see owner’s manual) remove screws securing
floor to assembly. Lift floor for access to bottom of fireplace.
Use two screws provided in fireplace hardware package
and attach fireplace base to wooden base (see Figure 11).
Reinstall floor with screws removed previously.
7. Place metal trim on shoulder screws. Firmly snap trim
assembly over shoulder screws on fireplace.
8. Carefully push mantel and base into position against
wall.
Installing Fireplace without Flange
1. Place mantel assembly on wood base and center left to
right having back of assembly flush with back of base.
2. Attach mantel to base using 1 1 /
4
" screws through pocket
holes. Using brackets and 1/2" or 3/4" screws from
bracket hardware kit, attach brackets to base and mantel
assembly using one bracket at each back corner of leg
sides and one on each leg front (see Figure 9, page 3).
3. Position fireplace inside mantel (see Figure 12). Care-
fully position gas lines. IMPORTANT: Use caution when
positioning fireplace on base. Base may scratch easily.
4. Fireplace with louver door: Lower bottom louver door. Use
two screws provided in hardware package and attach
fireplace to wooden base (see Figure 10). Close louver
door
Fireplace with fixed louver: Before installing logs or burner
assembly (see owner’s manual) remove screws secur-
ing floor to assembly. Lift floor for access to bottom of
fireplace. Use two screws provided in fireplace hardware
package and attach fireplace base to wooden base (see
Figure 11). Reinstall floor with screws removed previ-
ously.
5. Place metal trim on shoulder screws. Firmly snap trim
assembly over shoulder screws on fireplace.
6. Carefully push mantel and base into position against
wall.
Figure 11 - Screw Locations for Fireplaces with Fixed Louver
Screws
Holes are Behind Louver on
Fireplace Bottom for Attaching
Fireplace to Wooden Mantel
Base.
Fixed
Louver
Figure 10 - attaching Fireplace to mantel and mantel Base
O F F
P ILO T O N
H I L O
Hole for Attaching
Fireplace System to
Wooden Mantel Base
Bottom
Louver Door
Assembled
Metal Trim
Mantel
Base
Shoulder
Screws
Possible
Shutoff
Valve
Locations
Figure 12 - Installing Fireplace without Flange
(Side view
for clarity)
Shoulder Screw