Hisense Group LCD3201EU - Manual (Page 10)

Press [Display] button to display the present channel number, but it will also disappear 6 seconds after your pressing.
Display channel number
Press the [ Still ] button to snapshot the present picture, and press again to return to normal watching.
Use [Still] button
Press the [ Zoom ] button to adjust the screen aspect ratio and zoom ratio
Use [ Zoom ] button
Press [ Mute ] button repeatedly to switch between mute and unmute mode.
Mute function
Press the [ Recall ] button repeatedly to alternate between the present channel and the previous channel.
Use [Recall] button
You can select the picture mode from among three preset modes and one user-set
mode. Press the [ P.mode ] button repeatedly to select the desired picture mode.
Select picture modes
You can select the sound mode from among three preset modes and one user-set
mode. Press the [ S.mode ] button repeatedly to select the desired sound mode.
Select sound modes
Adjust Volume
When menu is not displayed on the screen, press to adjust the volume. [VOL+ or VOL-]
To select a channel : Press the channel numbers in series to select channel directly.
Press the button 1, and 1_ _ will display on the top right corner of the screen,
then press the button 2, 12_ will display, press the button zero, you can enjoy the program of channel 120.
For example, to seclect channel 120,
Select channels by numbers
NORMAL
USER
SOFT
BRIGHT
SPEECH
NORMAL
MUSIC
USER
Innovation is life
Using the TV features
- 9 -
NOTE:
1)
When you changing the channel, the sound state graphics can be displayed below the channel number. There
are 3 sound states in this TV. If the sound is mono, the graphics is , If the sound is stereo, the graphics is
If the sound is NICAM dual I/II, the graphics is .
Which indicate preset of picture system and sound system.
When you changing the channel, the sound of current channel will be firstly changed to stereo or NICAM dual I
according to the sound state of current channel. You can press the
I/II button on the remote control to change
current sound type.
3) When you press the 0 channel . The AV source will be seleced . When you press the VIDEO button ,It will
return TV source.
2)
There are two symbol at right of the sound state graphics,