HONDA FG110 - Manual (Page 38)

36
TECHNICAL & CONSUMER INFORMATION
Air Index
An Air Index Information hang tag/label is applied to engines certified to an emission durability time period in
accordance with the requirements of the California Air Resources Board.
The bar graph is intended to provide you, our customer, the ability to compare the emissions performance of
available engines. The lower the Air Index, the less pollution.
The durability description is intended to provide you with information relating the engine’s emission durability
period. The descriptive term indicates the useful life period for the engine’s emission control system. See your
Emission Control System Warranty for additional information (see page 41).
The Air Index Information hang tag/label must remain on the trimmer/brush cutter until it is sold. Remove the hang
tag before operating the trimmer/brush cutter
SPECIFICATIONS
* Actual fuel consumption will vary depending on engine load conditions.
Descriptive Term Applicable to Emissions Durability Period
Moderate 50 hours (0–65 cc)
125 hours (greater than 65 cc)
Intermediate 125 hours (0–65 cc)
250 hours (greater than 65 cc)
Extended 300 hours (0–65 cc)
500 hours (greater than 65 cc)
ENGINE
Model GX25
Type 4-stroke, overhead cam, single cylinder
Description code GCAAM
Displacement 1.5 cu in (25 cc)
Bore & stroke 1.4 x 1.0 in (35 x 26 mm)
Maximum horsepower 1.1 hp (0.81 kW) at 7,000 rpm
Maximum torque 0.94 lbf•ft (1.25 N•m, 0.13 kgf•m) at 5,000 rpm
Compression ratio 8.0:1
Fuel consumption* 0.559 lb/HPh (340 g/kWh, 250 g/HPh)
Cooling system Forced-air
Ignition system Transistorized magneto
Ignition timing 30° B.T.D.C. (Fixed)
Spark plug CMR5H (NGK)
Carburetor Diaphragm type
Air cleaner Semi-dry type
Lubrication system Oil mist
Oil capacity 2.7 US oz (80 cc, 2.8 Imp oz)
Recommended operating ambient temperature 23°F ~ 104°F (-5°C ~ 40°C)
Starting system Recoil starter
Stopping system Ignition primary circuit ground
Fuel used Unleaded gasoline with a pump octane rating of 86 or higher
Fuel tank capacity 0.14 US gal (0.55 , 0.12 Imp gal)
PTO shaft rotation Counterclockwise (from PTO shaft side)