Operation - al650, Not locked locked al 650 - loading a power chair – Harmar Mobility AL600 User Manual
Page 12

Parking the Chair on the Platform: Before
loading the power chair, verify that the 
platform has been lowered all the way to the 
ground. Set your chair’s speed control at a 
slow speed so that you may maneuver 
comfortably onto the platform. Drive the 
chair onto the platform into the opening of 
the docking station. 
Raising the Chair: Before raising, verify that 
the chair is secured to the platform. While 
holding the hand control stand to the side and 
away from the lift. Press the up button. The 
lift will rai se and retract into the vehicle. The 
lift is retracted fully when the platform is fully 
inside of the vehicle and the lift’s motion stops.
At this point release the button. Secure the hand
control by placing it on the hook and loop 
patch attached to the lift. Close the rear door 
carefully taking notice of any baskets, 
backpacks or additional items attached to the 
chair that may be hit by the door.
Verify Chair is 
locked onto 
Platform
TO RELEASE CHAIR
Slide knob this direction
To Unload Chair: Lower Platform to the 
ground. Push knob as shown to the right.
Drive off chair in reverese. The Docking 
Station will automatically reset itself to 
accept the next time the chair is loaded.
THREE WAYS TO VERIFY YOUR CHAIR
IS SUCCESSFULLY LOCKED DOWN
1) AUDIBLE "CLICK or POP" SOUND
3) REVERSE TEST
2) VISUAL INDICATOR
The yellow indicator will extend and stay
extended when the chair is 
successfully
locked in place.
Attempt to back the chair off the platform.
The chair will NOT move in any direction
when successfully locked.
As the chair enters the locking device,
it should be driven forward until an audible
pop or clicking sound is heard. This sound
is the locking device setting itself around 
the chair's docking device pin.
NOTE: During transport, vibration
may cause the chair to tighten itself in
the locking device, making the release
knob difficult to slide. To overcome this,
simply drive the chair forward a bit.
This will take pressure off the knob,
allowing an easier release.
NOT
LOCKED
LOCKED
AL 650 - LOADING A POWER CHAIR
12
