Husqvarna HUV4210-EXP - Manual (Page 29)

Storage – Gasoline Vehicles
2006 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner’s Manual Page 27
2.4. Plug the fuel tank vent nipple so that it is air tight. We recommend using a slip-on vinyl cap.
3. Disconnect the battery cables, negative (–) cable first.
4. Batteries should be clean and free of corrosion. Wash tops and terminals of batteries with a solution of
baking soda and water (1 cup (237 mL) baking soda per 1 gallon (3.8 L) of water). Rinse solution off bat-
teries. Do not allow this solution to enter the batteries. Be sure terminals are tight. Let the terminals dry
and then coat them with Battery Terminal Protector Spray (Husqvarna 603 00 00-03).
5. To protect the engine, remove spark plug and pour 1/2 ounce (14.2 mL) of SAE 10 weight oil into the
engine through the spark plug hole. Rotate engine crankshaft by hand several times, then install the
spark plug and tighten to 20 ft-lb (27 N·m).
6. Adjust tires to recommended tire pressure. See Vehicle Specifications on page 46.
7. Perform semiannual periodic lubrication. See Periodic Lubrication Schedules on page 32.
8. Thoroughly clean front body, rear body, seats, engine compartment, and underside of vehicle.
9. Do not engage the park brake. Chock the wheels to prevent the vehicle from rolling.
Figure 16 Fuel Shut-off Valve – Closed Position
Figure 17 Fuel Shut-off Valve – Open Position Figure 18 Fuel Shut-off Valve –
Partially Closed Position
CLOSED (OFF) POSITION
(SELECTOR IS ALIGNED
WITH OFF MARKINGS ON THE SIDES OF VALVE)
OFF OFF
VIEWED FROM SELECTOR
SIDE OF VALVE
VIEWED FROM SELECTOR
SIDE OF VALVE
FULL OPEN (ON)
POSITION
VIEWED FROM SELECTOR
SIDE OF VALVE
PARTIALLY CLOSED
POSITION