Husqvarna HUV4213 - Manual (Page 33)

Fueling Instructions
2005 HUV4213 Gasoline Vehicle Owner’s Manual Page 31
OIL VISCOSITY
Choose the viscosity according to the temperature as shown in the oil viscosity chart (Figure 23).
NOTE: Using multi-grade oils (5W-20, 10W-30, and 10W-40) will increase oil consumption. Check oil level
more frequently when using them.
FUELING INSTRUCTIONS
See General Warnings on page 8.
ý DANGER
• Turn the key switch to the OFF position before fueling.
• Never pour gasoline into the fuel tank when the engine is hot or while it is running.
• To avoid electric arc caused by static electricity, the fuel storage/pumping device must be
grounded. If the pump is not grounded, the vehicle must be grounded to the pump before and
during the fueling operation.
• If the vehicle has an all-weather enclosure installed, be sure the fuel tank is properly vented as
shown (Figure 24, Page 32).
• To avoid the possibility of fire, clean up any spilled gasoline before operating the vehicle.
ý CAUTION
• To allow for expansion, do not fill higher than one inch (2.54 cm) from the top of the fuel tank.
Avoid spilling fuel.
1. Remove the passenger seat.
2. Remove fuel cap and fill tank with fresh unleaded gasoline only. See preceding DANGER and CAU-
TION.
Figure 23 Oil Viscosity Chart
SAE 5W-20
SAE 10W-30/SAE 10W-40
SAE 30
SAE 40
-20° C -10° C 0° C 10° C 20° C 30° C 40° C
-4° F 14° F 32° F 50° F 68° F 86° F 104° F