Samsung 30 Inch Freestanding Gas Smart Range Owners Guide - Manual (Page 42)

42 English
Maint
enanc
e
Maintenance
NOTE
Make sure all surface burners are off while
the oven is performing a self cleaning
cycle. Self-clean will not operate if a surface
burner is on.
To delay starting a self-cleaning cycle
5
2
3
4
1. Make sure the oven door is closed completely and unlocked.
2. Press Self Clean once. Then, select the cleaning time by pressing Self Clean one
or more times in accordance with the table below.
Once Twice Three times
3-hour cycle 5-hour cycle 2-hour cycle
3. Press Delay Start .
4. Set the time you want the oven to start self-cleaning using the number pad.
5. Press START/SET . The oven door locks, and the oven will start self-cleaning at
your specified time.
To cancel the self-cleaning cycle
You may find it necessary to stop or interrupt a self-cleaning cycle due to smoke in
the oven. To turn off the self-cleaning cycle, press
OFF/CLEAR . The cycle turns off,
but the door remains locked and the Lock icon blinks until the oven temperature
falls below 400 °F (204 °C).
After self-cleaning
•
The door stays locked until the internal oven temperature falls below 400 °F.
• When the oven has cooled down, wipe the oven surfaces with a cloth to remove
ash residue.
• Stubborn stains can be removed using a steel-wool pad. Lime deposits can be
removed using a vinegar-soaking cloth.
• If you are not satisfied with the cleaning results, repeat the cycle. “HOT” appears
on the display until the oven cools down. Wait until the message disappears, and
then start a new cycle.
• The cooling fan automatically runs for certain amount of time after self-cleaning.
• Self-cleaning does not operate within 2 hours after running the self-cleaning
cycle.
CAUTION
Do not attempt to open the oven door immediately after the self-cleaning cycle is
complete. The oven is still very hot when the door unlocks. Escaping hot air and/or
steam could burn you.