Pit Boss 45 Inch Portable Gas Grill Owners Guide - Manual (Page 14)

ENGLISH
14
MANUAL LIGHTING PROCEDURE
1. Open lid during lighting.
2. Set all control knobs to the "OFF" position.
3. Open the cylinder/gas valve according to the operating
instructions on tank.
4. Quickly and carefully, use a lit match secured with the lighting
rod (included with the grill) to light the burner. Gain access to
the burner through the cooking grids. Position lit match near
side of burner. Do not attempt to light another area of the
burner. This can cause injury.
NOTE: Do not use spirit, lighter-fluid or kerosene for
lighting or refreshing a fire in your grill.
5. If the burner does not light within 5 seconds, turn burner
control knob to “OFF”, wait 5 minutes, and repeat lighting
instruction. After lighting, observe the burner flame. Make
sure all burner ports are lit and flame height matches
illustration shown previously. Replace the Cooking Grid back
into position, and you are ready to enjoy your grill at your
desired temperature!
NOTE: Each burner lights independently - repeat same steps for other burners.
WARNING: Never lean over the cooking area while lighting your gas grill. Keep your face and body a safe
distance (at least 457 mm / 18 inches) from the cooking grid surface when lighting your grill by match.
6. If the above points do not work, see Troubleshooting.
SHUTTING OFF YOUR GRILL
1. Turn control knobs to the OFF position.
2. Disconnect LP gas cylinder by following the
Disconnect LP Gas Tank instructions.
NOTE: A “poof” sound is normal as the last of the LP gas is burned.
WARNING: Allow the grill to cool completely, and remove the gas cylinder, before moving, travel, or for
storage.