England's Stove Works 60-TRULP - Manual (Page 7)

IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY A FIRE OR
EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY
OR LOSS OF LIFE.
This unit has a piezo ignition pilot. When lighting the pilot, follow these instructions exactly.
A.
BEFORE LIGHTING, smell around the appliance area for gas. Be sure to smell next to
the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
1. Do not try to light any appliance.
2. Do not touch any electrical switch; do not use the phone in your building.
3. Call the gas supplier from a neighbor’s phone. Follow their instructions.
4. Call the fire department if you cannot reach the gas supplier.
B.
Use only your hand to push in or turn the gas control knob — never use tools. If the knob
will not push in or turn by hand, do not attempt to repair it. Call a qualified technician.
Force or attempted repair may result in an explosion.
C.
Do not use the appliance if any part has been under water. Immediately call a qualified
service technician to inspect the unit and to replace any of the gas control that has been
under water.
D.
Do not use this appliance for burning trash or cooking. Never place matches, paper,
garbage or any other material on top of the logs or in the flame.
OPERATING INSTRUCTIONS
Pilot Gas and Lighting Procedure
1) Turn off all electric power to unit.
Remove control access panel.
2) Set thermostat to lowest setting.
3) Turn knob “A” clockwise to “OFF”.
4) Wait five (5) minutes to clear out any gas.
Smell for gas –STOP—follow safety precautions
if you do smell gas (If not go to step 6).
Find pilot – follow metal tube from gas control.
The pilot is between the two burner tubes.
5) Turn knob “A” slightly counterclockwise towards
the “IGN” position until it stops. Press down and
hold for five seconds (only pilot gas flows).
6) Continue pressing knob “A” down while turning
further c/clockwise to activate the piezo. Continue
to hold down for ten (10) seconds after pilot light
has been lit. If the pilot light does not light, these
steps can be repeated immediately. (See note below)
Note: If pilot flame is not established, equipment
manufacturer (OEM) will determine the number of
additional attempts to light – and with continued
failure, the purge time required before further attempts.