Electrolux EKC5544 - Manual (Page 20)

Problem Possible solution
The oven light fails to illuminate. The oven light bulb may need replacing.
If the Main Oven is set for automatic cooking the
light will illuminate when the cook time begins.
The oven fan is noisy. Check that the oven is level.
Check that the shelves and bakeware are not vi-
brating in contact with the oven back panel.
The oven temperature is too high or too low. Check that the recommended temperatures and
shelf positions are being used. Be prepared to
adjust the temperature up or down slightly to ach-
ieve the results you want.
Installation instructions
Warning! THIS APPLIANCE MUST BE
EARTHED
If your appliance has been damaged in trans-
it, contact your supplier immediately. Do not
attempt to install it.
Your appliance left the factory fully packaged
to protect it from damage. If it is delivered
without packaging and damage has occur-
red, the manufacturer cannot accept respon-
sibility. Contact your supplier for advice.
Once the packaging has been removed the
appliance should only be moved by hand. Do
not use a sack barrow or any other aid to lift
the appliance as damage may occur.
Connection to the electricity supply must be
carried out by a qualified electrician/compe-
tent person.
The electrical connection should be made
using a double pole isolating switch (cooker
socket) with at least 3mm contact separation
in all poles. The cable must have conductors
of sufficiently high crosssectional area to pre-
vent overheating and deterioration.
The recommended cross-section area is six
square millimetres (6.00mm2).
When refitting the mains terminal cover, en-
sure that the lower tabs are located inside the
bottom edge of the aperture, before fixing the
two screws into the top edge of the mains
terminal cover.
Ensure that the cover is securely fastened.
To move the appliance, open the oven door,
and lift the appliance by holding inside the top
of the compartment.
This is a type Y appliance, which means it is
freestanding and can be fitted with cabinets
on one or both sides. It may also be fitted in
a corner setting.
Side walls which are above hob level should
be protected by heat resistant non-combus-
tible material and MUST NOT be nearer than
40mm to the hob side.
A nominal air gap of 2mm at either side of the
appliance is required to enable the appliance
to be moved into position.
20 electrolux