PLANET LRP-822CS - Manual (Page 103)

User’s Manual of LRP-822CS
103
 Link State Display the link state
 Active Member Display the active member
 Standby Member Display the standby member
 Modify
Click to modify LAG configuraiton
4.4.3 LAG Port Setting
This page allows setting configuration for each LAG. The LAG Port Setting screens in Figure 4-4-6 & Figure 4-4-7 appear.
Figure 4-4-6 LAG Port Setting Information Page Screenshot
The page includes the following fields:
Object Description
 LAG Selet Select LAG number from this drop-down list.
 Enable Indicates the LAG state operation. Possible states are:
Enabled - Start up the LAG manually.
Disabled – Shut down the LAG manually.
 Speed Select any available link speed for the given switch port. Draw the menu bar to
select the mode.
 Auto – Set up Auto negotiation.
 Auto-10M – Set up 10M Auto negotiation.
 Auto-100M – Set up 100M Auto negotiation.
 Auto-1000M - Set up 1000M Auto negotiation.
 Auto-10/100M – Set up 10/100M Auto negotiation.
 10M – Set up 10M Force mode.
 100M – Set up 100M Force mode.
 1000M – Set up 1000M Force mode.
 Flow Control When Auto Speed is selected for a port, this section indicates the flow control
capability that is advertised to the link partner. When a fixed-speed setting is
selected, that is what is used. The current RX column indicates whether pause
frames on the port are obeyed. The current TX column indicates whether pause