DE DIETRICH VZ9456E1 - Manual (Page 56)

56
In this fully integrated appliance the controls are
located on the top of the door. When selecting a
programme, the door needs to be partially opened.
1. Check the filters
Ensure they are clean and properly positioned
(see "Maintenance and cleaning").
2. Press the On/Off push button
The On/Off indicator light will illuminate.
3. Check that there is rinse aid and
salt
The salt indicator light will illuminate if refilling is
necessary.
4. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the plates,
saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
5. Ensure that the spray arms can
rotate freely.
6. Add the detergent
As all detergents are not the same, you should
also consult the instructions on the packet.
Close the detergent dispenser lid.
7. Setting the programme
Press the programme push button which
corresponds to the washing programme you wish
to select, the corresponding programme indicator
light starts flashing.
8. Start the programme
Open the water tap.
Close the dishwasher door.
An audible signal informs you that the
programme has started. The indicator light of the
programme under way is now permanently on.
9. At the end of the washing
programme
The dishwasher will automatically stop and
an audible signal informs you that the
programme has ended.
The "On/Off" indicator light flashes and the
indicator light of the programme turns off.
Open the door and press the On/Off push
button to switch the dishwasher off.
Wait a few minutes before removing the
dishes, in this way they will be cooler and the
drying will be improved.
Empty the lower basket first and then the
upper one, this will avoid water dripping from
the upper basket onto the dishes in the lower
one.
10. To cancel a programme in
progress
If the door has not been closed and the wash
programme has not started, to cancel the
programme simply press the push button of a
different wash programme.
To cancel a wash programme in progress,
open the door and press the push button of
the programme under way until the relevant
indicator light goes out.
The dishwasher is now in setting mode and a
new washing programme can be selected.
When the washing programme has
finished, it is recommended that the
dishwasher is unplugged and the water
tap turned off.
In general it is not advisable to open the
door while the machine is working; if the
door is opened however, a safety device
ensures that the machine stops.
Important!
Care must be taken if the door is opened
during the hot phase or immediately
after a programme has finished, as
steam may escape.
Operating sequence