Subaru Robin EX35 - Manual (Page 17)

US
NOTE
Clean and replace air cleaner elements more often when
operating in dusty environments. Replace the element in
case that dirt or dust can not be removed and/or that the
element is deformed or deteriorated.
8. CHECKING BOLTS, NUTS AND SCREWS
Retighten loose bolts and nuts.
Check for fuel and oil leaks.
Replace damaged parts with new ones.
9. CHECK BATTERY
7. FUEL HOSE REPLACEMENT
(See Fig.7 7 7 7 7-!1 !1 !1 !1 !1)
Replace the fuel hose every 2 years. If fuel leaks from fuel
hose, replace the fuel hose immediately.
Take extreme caution when replacing fuel
hose ; gasoline is extremely flammable.
WARNING
WARNING Flame Prohibited
If the electrolyte fluid is below level line, refill with distilled
water to the upper level line.
10. HIGH ALTITUDE ENGINE OPERATION
Please have an authorized Robin America service dealer
modify this engine if it is to be run continuously above
5000 feet (1500 meters). Failure to do so, may result in
poor engine performance, spark plug fouling, hard
starting, and increased emissions.
Carburetor modification by an authorized Robin America
service dealer will improve performance and allow that
this engine meets EPA (Environmental Protection
Agency) and California ARB (Air Resources Board)
emission standards throughout its useful life.
An engine converted for high altitudes can not be run at
5000 feet or lower. In doing so, the engine will overheat
and cause serious engine damage.
Please have an authorized Robin America service dealer
restore high altitude modified engines to the original
factory specification before operating below 5000 feet.
1. DISCHARGE FUEL (See Fig.8 8 8 8 8-q q q q q)
If you do not use the engine more than 1 month, discharge
fuel to prevent gum in the fuel system and carburetor parts.
Remove the fuel cup, place it over a container and open
the fuel cock to discharge fuel from the fuel tank.
Remove the drain screw of the carburetor float chamber
and discharge fuel.
2. ENGINE OIL
Change the engine oil with fresh oil.
Remove the spark plug, pour about 5 cc of engine oil
into the cylinder, slowly pull the starter handle of the
recoil starter 2 or 3 times, and reinstall the spark plug.
3. CLEAN AND STORE
Slowly pull the recoil starter handle until resistance is
felt and leave it in that position.
Clean the engine thoroughly with an oiled cloth, put the
cover on, and store the engine indoors in a well
ventilated, low humidity area.
4. BATTERY CHARGING
WARNING Flame Prohibited
8. PREPARATIONS FOR STORAGE
The battery discharges itself even when not connected,
therefore it is necessary to recharge it once a month.
WARNING Flame Prohibited
1. FUNCTION OF OIL SENSOR
The engine will stop automatically when the oil level falls
below the safety limit. The engine cannot be started unless
the level is raised above the prescribed limit. (See Fig.2 w)
2. RESTARTING
(1) Fill the crankcase with oil up to the proper level.
(2) As for restarting and operating the engine, refer to section
“6. OPERATING YOUR ENGINE” on page 8 .
Check the wire connector from the engine. It must be
connected securely to the wire from oil sensor.
When selecting the engine oil, refer to page 5 for the
recommended oil.
9. OIL SENSOR INSTRUCTIONS
(OPTIONAL)
07.12.13, 0:51 AM Page 11