Sealey AP1200R - Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE OR PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
3. CONTENTS
3.1 Carefully unpack the product and check the contents as
detailed in Fig.3. Should any items be missing or damaged
contact your Sealey dealer.
4.1 We recommend that this shelving unit be assembled by two
people. Although unnecessary, the use a rubber mallet or a
hammer and a piece of wood can be used to aid assembly.
Do not use a hard faced hammer directly on the 'Z' beams as
this will damage their surface finish. Make sure that
all the 'Z' beams are fully interlocked with the angle posts
before using the unit. (The rivets on the 'Z' beams must seat
at the bottom of the keyhole slots ). Do not use any parts that
are damaged and/or distorted as these may assemble
incorrectly and result in an installation that is unsafe, which
may cause injury or damage when the shelves are loaded.
Fig.2
Fig.3
InSTruCTIonS For:
RACKING UNIT WITH 5 SHELVES
MoDEL no's:
AP900R, AP1200R
1. SAFETY INSTRUCTIONS
1.1 GEnErAL SAFETY

W A RNING! Ensure Health & Safety, and local authority
regulations are adhered to when assembling and using these
shelves.
 Locate shelves in a suitable area where they will not be an
obstruction.

Keep the general area clean, uncluttered and ensure there is
adequate lighting.

WARNING! Erect shelves on a level and solid surface such as
concrete.

Keep children and unauthorised persons away from the storage
area.

DO NOT use the shelves for any purpose other than that for
which they are designed.

DO NOT site the shelves out of doors.

DO NOT get the shelves wet or use in damp or wet locations or
areas where there is condensation.
 DO NOT clean the shelf supports with any solvents which may
damage the coated surface.

Ensure that the shelves are properly assembled before loading
them with any items.

Where possible the unit should be fixed to the wall with
suitable fixings

Place heavier items on the lower shelves.

Where possible heavier items should be evenly distributed across
the shelves.
2. INTRODUCTION
4. ASSEMbLY
Fully painted steel frame with five chipboard shelves. 220kg / 340kg
Capacity per level giving a maximum capacity of 1100kg / 1700kg per
rack. Boltless design means no tools required to assemble. Slots
together in minutes. racking can be used as a single bay rack (Fig.1)
or split into two separate shelf systems or workstations (Fig.2).
. . . . . . . Height . . . . Width . . . . Depth . . . . Capacity per level
AP900R . . . 1830mm . . 915mm . . . 460mm . . . 340kg
AP1200R . . 1830mm . . 1220mm . . 460mm . . . 220kg
Fig.1
AP900r, AP1200r Issue: 1 - 05/06/09