Sealey LED033 - Manual (Page 2)

3.1.3. to use the lamp, plug the transformer plug into the mains socket to turn the light on.
3.1.4. When finished, disconnect the transformer plug from the mains supply and store the lamp in a safe, dry and
childproof location.
3. OPERATION INSTRUCTIONS
4. MAINTENANCE
3.1. ATTACHING LAMP TO BONNET.
3.1.1. Place the padded hook at the end off the lamp, over one edge of the bonnet, and gently pull the lamp towards
the other side of the bonnet.
3.1.2. steady the lamp with one hand, whilst extending the hook over the other side of the bonnet.
4.1. Keep lamp clean and check for damage before every use. If damage is observed remove from use until unit is
repaired.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534 [email protected]
Sole UK Distributor, Sealey Group,
Kempson Way, suffolk Business Park ,
Bury st. Edmunds, suffolk,
IP32 7Ar
www.sealey.co.uk
W e b
email
Original Language Version LED033 Issue: 1 - 29/01/13
robust design with built-in spring loaded telescopic mounting brackets. soft padded hooks provide good protection
against bonnet. 30 sMD LEDs give complete engine bay illumination. supplied with 5mtr cable and transformer plug,
reducing down to 12V for added safety.
Model No: ........................................................... LED033.
Voltage: .................................................................... 230V.
Power:....................................................................... 12W.
Minimum/ Maximum Bonnet Width ....... 1230/1940mm.
Lamp Type:............................................. 30 x 3528 sMD.
2. INTRODUCTION
© Jack sealey Limited
Environmental Protection.
recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which
is compatible with the environment.
WEEE Regulations.
Dispose of this product at the end of its working life in compliance
with the Eu Directive on Waste Electrical and Electronic Equipment.
When the product is no longer required, it must be disposed of in an
environmentally protective way. contact your local solid waste
authority for recycling information.