Fig.2 fig.3 charging battery removal, replacement, Operation – Sealey LED034 User Manual
Page 2
3.1. OPERATION
WARNING! Ensure that you read, and fully understand the safety instructions before use.
3.1.1. Charge the battery fully before use.
IMPORTANT: Ensure the torch is turned ‘Off’ whilst charging. Failure to do so will damage the charger plug.
3.1.2. The torch can be charged from the supplied 3 pin mains adaptor (fig.2).
3.1.3. A full charge takes approximatelty 4 hours, allowing up to 2 hours of use.
3.1.4. Whilst charging, a red LED shows in the SMD display; a green LED shows when charged.
3.1.5. As this torch is fitted with a Lithium-ion battery, it can be charged at any time; there is no ‘memory’ effect with this type of battery.
3.1.6 . The first press of the switch (fig.1) illuminates the CREE LED in the end, and one of 5 functions is illuminated “full beam”, “half beam”, “low
beam”, ”flashing” or “SOS”. Switch on and off to go to the next function. The function order remains, but the start function may differ.
3.1.7 The beam focus can be adjusted by holding the bezel and sliding the knurled handle as in (fig.1).
3.1.8 Battery removal/replacement is achieved by holding the knurled handle and unscrewing the end cap as in (fig.3). Note polarity when
replacing.
3. OPERATION
Original Language Version
LED034 Issue: 1 - 11/04/13
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park
,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Web
© Jack Sealey Limited
Environmental Protection.
Recycle unwanted materials instead of disposing of
them as waste. All tools, accessories and packaging should be sorted, taken to a recycle centre and
disposed of in a manner which is compatible with the environment.
Battery Removal (section 3.1.8).
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containing
batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack Sealey Ltd’s Batteries Producer
Registration Number (BPRN) is BPRN00705
WEEE Regulations.
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment.
When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid waste authority for recycling
information.
Fig.2
Fig.3
Charging
Battery removal, replacement