Powerplus POWXQG7556 LAWNMOWER 190CC 560MM EN - Manual (Page 16)

POWXQG7556 EN
Copyright © 2014 VARO P a g e | 16 www.varo.com
Before reassembling the blade and the blade adapter to the unit, lubricate the engine
crankshaft and the inner surface of the blade adapter with light oil. Install the blade adapter on
the crankshaft with the "star" away from the engine. Refer to figure 15. Place the blade with
the part number facing away from the adapter. Align the washer over the blade and insert the
hex bolt. Tighten the hex bolt to the torque listed below:
8.3.3 Blade mounting torque
Centre Bolt 40Nm-50Nm, to insure safe operation of your unit. ALL nuts and bolts must be
checked periodically for correct tightness.
After prolonged use, especially in sandy soil conditions, the blade will become worn and lose
some of the original shape. Cutting efficiently will be reduced and the blade should be
replaced. Replace with an approved factory replacement blade only. Possible damage
resulting from blade unbalance condition is not the responsibility of the manufacturer.
When you change the blade you must use the original type marked on the blade.
9 STORAGE INSTRUCTIONS (OFF SEASON)
The following steps should be taken to prepare lawn mower for storage.
1.
Empty the tank after the last mowing of the season.
 Empty the petrol tank with a suction pump.
Caution! Do not drain the peterol in closed rooms, in close proximity of
open fire, etc. Do not smoke! Petrol fumes can cause explosion or fire.
 Start the engine and let it run until it has used up all remaining petrol and stalls.
 Remove the spark plug. Use an oilcan to fill approx. 20 ml oil into the combustion
chamber. Operate the starter to evenly distribute the oil in the combustion chamber.
Replace the spark plug.
2. Clean and grease the lawnmower
carefully as described above under “Lubrication”.
3. Slightly grease the cutter to avoid corrosion.
4. Store the lawnmower in a dry, clean and frost-protected place, out of reach of
unauthorized persons.
Caution! The engine must have completely cooled down before storing the
lawnmower.
NOTE:
 When storing any type of power equipment in an unventilated or material storage shed,
care should be taken to rust-proof the equipment. Using a light oil or silicone, coat the
equipment, especially cables and all moving parts.
 Be careful not to bend or kink cables.
 If the starter rope becomes disconnected from rope guide on handle, disconnect and
ground the spark plug wire, Depress the blade control handle and pull the starter rope out
from engine slowly. Slip the starter rope into the rope guide bolt on handle.
10 TRANSPORT
Turn the engine off. Ensure not to bend or damage the cutter when pushing the lawnmower
over obstacles.