Parkside PABSW 10.8 B3 - Manual (Page 42)

42
GB
ance may be damaged and longer
charging times would be a waste
of energy. Excessive charging will
void the warranty.
• Charge the battery before the first
time of use. Do not briefly charge
the battery several time in a row.
• Recharge the battery when you no-
tice that the appliance is becoming
slower.
• If a fully recharged battery lasts
for considerably shorter operating
times, the battery is used up and
needs to be replaced. Only use an
OEM spare battery available from
our Customer Service.
• Always take heed of the applicable
safety instructions as well as the en-
vironmental protection regulations
and information.
• The warranty excludes all defects
caused by improper handling.
Removing / inserting the
battery
1. To remove the battery ( 6) from
the appliance, press the release
button ( 7) on the battery and
pull out the battery.
2. To insert the battery ( 6), place
it on the guide track (20) and
push it back into the appliance.
It will audibly snap in.
Recharging the battery
1. Remove the battery ( 6) from
the appliance.
2. Inser the battery ( 6) in the
charging compartment of the bat-
tery charger ( 13). It will audi-
bly snap in.
3. Plug the battery charger ( 13)
into a mains outlet.
4. When the battery is fully re-
charged unplug the battery
charger ( 13) from the mains.
5. Pull the battery ( 6)out of the
battery charger ( 13).
Green LED lights up without battery
Charger ready
Green LED lights up
Battery such alleged charged
Red LED lights up Battery charging
Used batteries
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to be
replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information (see “Cleaning and Main-
tenance”).
Checking the battery charge
level
The battery’s ( 8) charge level is indicat-
ed by the charge state indicator ( 6).
Press the activation button battery indicator
on the battery.
The LEDs indicate the battery’s charge
level.
red-yellow-green =Battery fully charged
red and yellow =Battery half charged
red =Battery needs to be charged