Parkside PABSW 10.8 B3 - Manual (Page 40)

40
GB
6) SERVICE
Have your power tool serviced by
a qualified repair person using
only identical replacement parts.
This will ensure that the safety of the
power tool is maintained.
7) SPECIAL SAFETY DIRECTIONS FOR
BATTERY-OPERATED TOOLS
a) Ensure that the device is switched
off before inserting the battery.
Inserting a battery into a power tool that
is switched on may result in accidents.
b) Recharge the batteries indoors
only because the battery charger
is designed for indoor use only.
c) To reduce the electric shock haz-
ard, unplug the battery charger
from the mains before cleaning
the charger.
d) Do not subject the battery to
strong sunlight over long periods
and do not leave it on a heater.
Heat damages the battery and there is a
risk of explosion.
e) Allow a hot battery to cool before
charging.
f) Do not open up the battery and
avoid mechanical damage to the
battery. Risk of short circuit and fumes
may be emitted that irritate the respiratory
tract. Ensure fresh air and seek medical
assistance in the event of discomfort.
g) Do not use non-rechargeable bat-
teries!
8) CORRECT HANDLING OF THE BAT-
TERY CHARGER
• This device can be used by children
aged 8 and over and by people with
reduced physical, sensory or mental
capacities or with a lack of experience
or knowledge, if they are supervised or
have been instructed regarding safe use
of the device and understand the result-
ing risks. Children are not permitted to
play with the device. Cleaning and user
maintenance are not to be undertaken by
children without supervision.
• Keep the equipment away from children
and pets. Children should be supervised
in order to ensure that they do not play
with the equipment.
• To charge the battery, use only
the charger supplied.
Risk of fire and explosion. This ensures
that the safety of the device is maintained.
• Before each use, check the charg-
er, cable and plug and have them
repaired by qualified profession-
als and only with original parts.
Do not use a defective charger and do
not open it up yourself. This ensures that
the safety of the device is maintained.
• Connect the charger only to a
socket with an earth. Ensure that
the mains voltage matches the
specifications on the charger rat-
ing plate. Risk of electric shock.
• Disconnect the charger from the
mains before closing or opening
connection to the battery / power
tool / device.
• Keep the charger clean and away
from wet and rain. Do not use
the charger outdoors. Dirt and the
entry of water increase the risk of electric
shock.