Electrolux DS603 - Manual (Page 34)

28
Fault codes
How to Recognize a Fault Code
When a fault has occurred, the DishDrawer® will continuously beep every second.
The fault code will be displayed on the electronic display for prefinished models and on the
inside control panel for integrated models.
Each fault code is shown in the following chart for prefinished and integrated models.
How to Attend to a Fault Code
1 Press the button to remove the fault code.
2 If the fault code and continuous beeps cannot be removed by pressing the button, turn the
power off at the power supply.
3 We recommend you check the following chart and correct the fault where possible.
4 After attending to the fault, turn the DishDrawer® on at the power supply.
5 If the fault code and continuous beeps remain, turn the water and power supply off to the
DishDrawer®.
6 When calling your Authorized Service Center advise them of the fault code that has appeared
on the DishDrawer®. This information will help the Authorized Service Center respond to your
request.