Airaid 1001 - Manual (Page 2)

Instructions Revision
04.11.14
6. Reinstall the throttlebody onto the intake manifold using the
factory hardware. Tighten the nuts and bolts in a cross pattern
to the vehicle manufacturer’s specifications. Before starting the
engine, open and close the throttlebody to make sure there are
no obstructions.
7. Reinstall the intake tube and tighten the two hose clamps.
Next, reattach the intake tube to the radiator hose via the plas-
tic clamp. Reinstall the breather tube into the intake tube. Re-
install the beauty cover. 8. Double check your work. Make sure there is no foreign ma-
terial in the intake tract. Make sure all clamps, connectors, hos-
es, nuts, and bolts are secure.
Reconnect the negative battery cable.
ECONOAID 2688 E Rose Garden Ln. Phoenix, AZ 85050 (888) 876-4676 www.ECONOAID.com
5. Install the ECONOAID Throttlebody Booster against the
manifold over the studs with the logo facing the throttlebody.
Next install the supplied gasket against the ECONOAID.
Fiber Gasket
ECONOAID
1.
2.
3.
4.
4. With a 10mm socket remove the two nuts, and the two bolts
that hold the throttle body to the intake manifold. Without
disconnecting the wiring harness, set the throttle body aside. 3. Next loosen the hose clamp on the intake tube at the throttle
body, and at the Mass Air Sensor, and then remove the tube
from the vehicle.