Airaid 510-503 - Manual (Page 2)

2
Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body air intake assembly.
3. Remove throttle linkage bracket and save 10mm bolt. (Ref. “D”)
4. Remove vacuum line clip from intake manifold and save 8mm bolt. (Ref. “E”)
5. Remove nuts and studs from the throttle body. (Ref. “B” & “C”)
6. Install power plate using (2) gaskets, (2) 8mm x 90mm bolts, (2) 8mm x 110mm bolts, and (4) 8mm lock
washers. (Ref. “A”, “B”, “C”)
A. Place one gasket between the throttle body and power plate.
B. Place second gasket between the power plate and manifold.
7. Install throttle linkage plate using 10mm x 20mm bolt and reinstall throttle linkage bracket using saved 10mm
bolt. (Ref. “D”)
8. Install extension plate using saved 8mm bolt (Step 4) and attach vacuum line clip to bottom side of extension
plate using furnished 5/16”-18 x 3/8” bolt. (Ref. “E”) (A slight tube adjustment might be needed.)
9. Inspect & Test throttle linkage for full Open & Closed travel before driving. Some cruise or kick down cables
may require adjustment. Please refer to your vehicles service manual for proper adjusting.
10. Reinstall air intake system using Step 2 as an example.
11. Reconnect battery cable. Enjoy!
The sound of power...The “whistle” means its working!
Ref. “A”- (1) Power Plate
(2) Gaskets
Ref. “B”- (2) 8mm x 90mm Bolts
(2) 8mm Lock Washers
Ref. “C”- (2) 8mm x 110mm Bolts
(2) 8mm Lock Washers
Ref. “D”- (1) Linkage Bracket Plate
(1) 10mm x 20mm Bolt
Ref. “E”- (1) Extension Plate
(1) 5/16”-18 x 3/8” Bolt
Rev. 04/19/07
AIRAID Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 [email protected] www.airaid.com