HP Spectre x2 - Manual (Page 28)

Connecting the tablet to the keyboard base
To connect the tablet to the keyboard base, follow these steps:
1. Insert the tablet POGO pin connector docking port (1) into the keyboard base POGO pin docking
connector.
2. Slide the kickstand release button (2) down to release the kickstand from the tablet.
3. Position the kickstand (3) at the desired angle. The kickstand angle can be set from about 30 degrees to
150 degrees.
For extra comfort and stability when you are typing, angle the keyboard up to the touchscreen. This raises the
back of the keyboard about 10 degrees. Additional magnets hold the keyboard firmly in position.
NOTE: If you close the kickstand, you can leave the keyboard attached and position the keyboard behind the
tablet. The keyboard keys and TouchPad are locked to prevent you from accidently typing while the keyboard
is in this position.
20 Chapter 3 Using the keyboard base