Progressive Turf Equipment TDR-30 - Manual (Page 24)

23
16. Cut all plastic ties securing the wing stop
rod. Remove the 5/8” hex bolt and lock nut
from the upright brackets on the Outer
Wing and fasten the stop rod in place
between the mounting brackets.
17. Repeat steps 12-16 to properly mount the
RH Outer Wing Deck onto the RH Main
Wing Deck.
18. Connect the outer wing lift circuit to a
hydraulic power source (tractor or power
pack) and extend the cylinders until they
align with the mounting brackets on the
lift pivot bar. Place a washer on each
side of the mount and each side of the
cylinder ends. Install the cotter pin
through each end of the pin.
Wing Stop
Rod
(4) Washers
Outer Wing Deck Installed onto Main Wing Deck